Purge the railroad ties!

ytsemaddy(z5 IL)May 22, 2008

I'd like to pick the communal landscaping brain. My house suffers from the "typical 80's tiered railroad tie garden" syndrome. We're aiming to remedy that ASAP. What's the most efficient / safest way to remove ties and the 8" lengths of rusty rebar that's holding them in the ground? Some of the ties have rotted pretty thoroughly, so those have been removed, but many are largely intact. My only minor success with pulling the rebar has been with locking pliers, but as most of them are rusty, the rust generally just ends up flaking away and there's not a good surface to grip on.

Any suggestions are greatly appreciated. We're thinking of taking this on over the long weekend. Thanks!

Thank you for reporting this comment. Undo
ronlarimer_zone7

I would hit them with a sledge hammer to widen the hole in the ground and then lift them out.

    Bookmark   May 22, 2008 at 4:37PM
Thank you for reporting this comment. Undo
laag(z6CapeCod)

Pick axe. Swing the head under the end of the tie and use it to lift the tie in the same manner you use a hammer on a nail.

A sawzall with a long metal blade is not the worst thing either if you can fire it up and ease it between the seam to cut the nails. You have to be careful, though, because if the blade bottoms out it will break.

    Bookmark   May 22, 2008 at 6:22PM
Thank you for reporting this comment. Undo
ytsemaddy(z5 IL)

The funny thing is that I tried the pickaxe method last fall. I apparently didn't get the head far enough under the tie, since the edge of the wood broke as I was pulling back on the pickaxe, which sent me sprawling backwards and I ended up with a sprained wrist! I think if I try it again this week I'll wear my rollerblading guards. :)

    Bookmark   May 23, 2008 at 9:10AM
Thank you for reporting this comment. Undo
stevega

The bigger the pry bar, the better. Use scrap 2X4 or 4X4 as a fulcrum. To remove the rebar, tap side to side to loosen. Then clamp big locking pliers down low and use the pry bar against the locked pliers.
Just before using these techniques, I broke the pick axe handle and went flying backwards. Being on a slope made it even more spectacular. Fortunately, no injuries.

    Bookmark   May 23, 2008 at 9:38AM
Thank you for reporting this comment. Undo
dee_can1

I'm faced with the same problem of getting them out. The neighbour's railway tie wall pushed over onto our property a long time ago, and they need to be removed sooner rather than later. (Man, those things smell.)

Anyway, once you get them out, how do/will you dispose of them? Where?

    Bookmark   May 23, 2008 at 7:39PM
Thank you for reporting this comment. Undo
Embothrium(USDA 8 Sunset 5 WA)

If using power saw I'd wear something to protect me from toxic dust being thrown up. I also wonder where off-site disposal could take place. I think the transfer station near me doesn't even accept flourescent lights! Everything gets dumped on the floor, where it is eventually scooped up by an earth mover - they took out the pits when they built a new facility.

    Bookmark   May 24, 2008 at 1:39PM
Sign Up to comment
More Discussions
Show Me Your Small Private Backyard Landscaping
Looking for picture-based examples of up to a 1/4 acre...
Bob Sislow
Mulch/grass over asphalt?
Our entire backyard was paved with asphalt by the previous...
stevet47
Need tips to make garden spiral
so this is kind of embarrassing but I don't know how...
violetwest
need help regrading
hi, currently the mulch surrounding my home foundation...
mishyq
Front Yard Landscape Help! Zone 10a
We are looking to remodel the front of our home. We...
honesthouse
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™