Tru-cut C25 Back Lapping

diamondiconsFebruary 9, 2013

Does anyone have the instructions to back lap a Tru-cut C-25 mower. Thanks! Mike

Thank you for reporting this comment. Undo
rustyj14(W/PA)

Well, i ain't never tried it, but it sure sounds interesting! Isn't that something you do with diamonds?
The only thing i do is: Remove blade, turn on bench grinder, set blade on tool rest, and slide blade along the turning grinding wheel. I check it some, then when it is uniform in shape, i figger its about right.
As for balance--i figger, if ya have to remove so much metal to make it look nice, and balance it----ya might as well replace it! Also--the first time ya hits a stone, or edge of sidewalk, there goes yer nice lapped edge!

    Bookmark   February 20, 2013 at 2:21PM
Thank you for reporting this comment. Undo
    Bookmark   February 24, 2013 at 11:38AM
Sign Up to comment
More Discussions
Honda HRX217
Had it for 10 years and is the best mower I ever had....
bob3d
john deere RX75 belt diagram
I have a Rx75 with 9hp motor. I bought it used and...
jeremy_2010
Champion Spark Plug lack of quality
Picked up a set of RJ12C's to have on hand when I do...
yt125
Advice Needed on a Used Mclane Reel Mower
Hello! I live in Southern California (San Fernando...
hbcsc153
Bad ignition coil magneto on Tecumseh
Is there a more economical solution to replacing a...
don_v
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™