Cluth/Self Propel adjustment on Tru-Cut

ajones(7)April 13, 2012

All,

I have a Tru-Cut 20 inch Homeowners unit that i've owned for about 5 years. I recently got it back from being sharpened but mistakenly did not have them adjust the clutch or self propel. I can not locate my manual to see if there are instructions for this in it but does anyone know if this is simple enough to do for a DIY'er?

If so can you include instructions?

thanks all!

Thank you for reporting this comment. Undo
david_tx(7a North Texas)

I'm not sure about the homeowner unit. If it's the same as mine, you need two 1 inch wrenches. One needs to be thin. I bought the cheapest wrench I could find and ground it down. There are two nuts side by side. Back one off, tighten the other, then tighten the first one back.

I have no mechanical skills but had no trouble adjusting mine, once I made my thin wrench.

    Bookmark   April 13, 2012 at 2:43PM
Thank you for reporting this comment. Undo
ajones(7)

thanks david for the quick response, i will check it out when i get home today!

    Bookmark   April 13, 2012 at 3:08PM
Sign Up to comment
More Discussions
Bad ignition coil magneto on Tecumseh
Is there a more economical solution to replacing a...
don_v
Mclane 20" mower at Sears... why so inexpensive?
Hey everyone, I want to get yall's input on a mower...
bobbarker14
Craftsman ZTS 7500
Going to look at a used one of these tomorrow. Anything...
radlee30458
Snapper commercial refurb
This is the 1986 snapper 21500PC that I found in the...
snapperfreak
Advice Needed on a Used Mclane Reel Mower
Hello! I live in Southern California (San Fernando...
hbcsc153
© 2015 Houzz Inc. Houzz® The new way to design your home™