Toro Recycler rear pivot arm

phil429147April 28, 2012

I'm trying to replace a rear pivot arm on a model 20332 Toro Recycler. After removing the wheel, retainer ring, pinion gear, and washers, I'm not sure how to get the pivot arm removed. The new part is threaded, so I'm assuming the old part is also. I soaked everything with PB Blaster, now what?

Before I strongarm this and cause damage, is there something

I am missing?

Thank you for reporting this comment. Undo
tomplum

Best to just block the arm and give the nut assy behind the arm a quick snap. They tend to lock in tight.

    Bookmark   April 29, 2012 at 12:25AM
Sign Up to comment
More Discussions
Snapper commercial refurb
This is the 1986 snapper 21500PC that I found in the...
snapperfreak
I have a Tecumseh 5hp egine no spark
I measure the ohms from the following. I placed one...
Nutty1269
need a mower
Hi. I'm trying to find a decent self propelled walk...
mjgarden1
snow throwing
older blower. 7hp, 24" width, 14" auger....
joe_mn
New Honda HRX Drive System
I see where Honda is presenting a new drive system...
skipmarr
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™