Lawn-Boy model 10682 mower

stonemesaApril 20, 2013

SN 28xxxxxxxx271

I'm looking for help replacing the drive belt. I've searched and found a few tidbits on how it's done but I still need some help.
I can figure out how to remove the belt on the pulley below the blade but the part of the belt that goes around the pulley on the rear (transmission) has me baffled. There is a guide of some type above that rear pulley and I don't think I can get the belt between that and the pulley. What bolts to I need to remove to get the belt on the rear tranny pulley? I guess Toro/Lawnboy no longer makes service manuals for their mowers anymore because I couldn't find one to purchase either.

Thank you for reporting this comment. Undo
tomplum

The Toros like this you do have to remove the rear guide, so I assume you will. If any of the 3 retaining screws are loose- set them with adhesive on reassembly. I think that i had to drop the axle down on the transmission side to get room to work.

    Bookmark   April 20, 2013 at 9:54PM
Thank you for reporting this comment. Undo
stonemesa

how do I remove the rear guide? To drop the axle, do I have to remove the cover on the transmission? I'm still trying to figure out how to get at the guide on top of the transmission.

    Bookmark   April 21, 2013 at 9:55AM
Sign Up to comment
More Discussions
need a mower
Hi. I'm trying to find a decent self propelled walk...
mjgarden1
Looking to replace the LB
I've been using a 2003 Lawnboy 10323 for over a decade...
pacochu
john deere RX75 belt diagram
I have a Rx75 with 9hp motor. I bought it used and...
jeremy_2010
Advice Needed on a Used Mclane Reel Mower
Hello! I live in Southern California (San Fernando...
hbcsc153
snow throwing
older blower. 7hp, 24" width, 14" auger....
joe_mn
© 2015 Houzz Inc. Houzz® The new way to design your home™