Ryobi 890r Trimmer

aaronjvanceApril 7, 2013

I have just finished rebuilding my trimmer and it is running great. The issue I have now is the attachment will not spin. Any ideas?

Thank you for reporting this comment. Undo
homegrown55(9)

It may be a clutch issue. It appears this model has the E-Z Link type split boom from the diagrams I have seen. Most trimmers except cheap ones have a clutch. When you reassembled did you remember to tighten up the T-20 Torx screw inside the clutch drum to the end of the crankshaft? Did you remove and re-install the clutch itself on the crankshaft? Did you properly install the large washer that goes on the shaft with the clutch?
In lieu of a broken upper drive shaft, check it and also check the drive shaft of your attachment(s) to verify they turn freely. If the upper shaft turns freely by hand then the clutch may not operating correctly when the unit is running. post back and let us know.

    Bookmark   April 7, 2013 at 7:56PM
Sign Up to comment
More Discussions
Need Craftsman mower grass bag
I have a very old, but really good condition Craftsman...
olddaddy
I have a Tecumseh 5hp egine no spark
I measure the ohms from the following. I placed one...
Nutty1269
Craftsman ZTS 7500
Going to look at a used one of these tomorrow. Anything...
radlee30458
snow throwing
older blower. 7hp, 24" width, 14" auger....
joe_mn
Advice Needed on a Used Mclane Reel Mower
Hello! I live in Southern California (San Fernando...
hbcsc153
© 2015 Houzz Inc. Houzz® The new way to design your home™