Flywheel removal?

rustyj14(W/PA)May 18, 2011

Somebody please tell me why the engine makers don't thread the holes in the flywheel so a person could turn bolts or screws into them, to use a regular pulling tool?

Yesterday, i tried to use a gear puller to take off the flywheel of a "curb find" mower, but the lack of holes, or the lack of threaded holes, made me use the Chinese Hammer Trick! Works every time!

RJ

Thank you for reporting this comment. Undo
walt2002

Costs maybe .25 per hole, time etc, multiply that by a few hundred thousand. You got a curb find and you want to complain about the mfgs? :) Buy a $4 threading tap.

Walt Conner

    Bookmark   May 18, 2011 at 10:21PM
Thank you for reporting this comment. Undo
ewalk

Nah I would rather watch Rusty use the Chineese Hammer Trick lol !

    Bookmark   May 19, 2011 at 5:42AM
Sign Up to comment
More Discussions
Champion Spark Plug lack of quality
Picked up a set of RJ12C's to have on hand when I do...
yt125
john deere RX75 belt diagram
I have a Rx75 with 9hp motor. I bought it used and...
jeremy_2010
Craftsman ZTS 7500
Going to look at a used one of these tomorrow. Anything...
radlee30458
Mclane 20" mower at Sears... why so inexpensive?
Hey everyone, I want to get yall's input on a mower...
bobbarker14
Engine trouble! B&S 13.5hp
My old Heritage ride-on has a Briggs& Stratton...
Over_here
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™