honda model hrt216sdr mower wheels not pulling

comeonin37August 23, 2009

I have a honda mower model HRT216SDA.

I replaced the transmission and clutch arm because the clutch arm was worn as well as the tip that extends up from the transmission where the clutch arm attached. I also installed a new belt.

The problems is when I pull the drive control cable the wheels will turn but it has no pulling power. I can see the cable move and when I lift the real wheels off the ground the wheels turn, but as soon as I put the wheels back on the ground the mower will not move.

Before reinstalling I checked the gears in the wheels as well as the pinion gears and could see no wear.

Any help would appreciated

Thank you for reporting this comment. Undo
tomplum

Are the clutch gears perchance on backwards? If you position the "notch" (one of three) at the top of the gear from a side view, the flat goes to the back.

    Bookmark   August 23, 2009 at 3:05PM
Thank you for reporting this comment. Undo
loi2009

I had same problem, new trany in, new cable seem to move about 1/4 of an inch but mower still not have enough force to move on the grass.

    Bookmark   March 27, 2010 at 8:28AM
Sign Up to comment
More Discussions
Bad ignition coil magneto on Tecumseh
Is there a more economical solution to replacing a...
don_v
Craftsman ZTS 7500
Going to look at a used one of these tomorrow. Anything...
radlee30458
snow throwing
older blower. 7hp, 24" width, 14" auger....
joe_mn
Snapper commercial refurb
This is the 1986 snapper 21500PC that I found in the...
snapperfreak
Looking to replace the LB
I've been using a 2003 Lawnboy 10323 for over a decade...
pacochu
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™