craftsman w/ briggs motor will not run

motorhead1845November 22, 2012

it ran fine a couple of weeks ago. now it will run only form a few minutes on prime

model number for the engine is 10T802.

anuone have a diagram of the goevrnor spring attachs to the governor?

i cleaned the carb once. plug is good. today plan to clean air filter and gas cap vent.

Thank you for reporting this comment. Undo
bill_kapaun

Suggest you go to the Briggs website and download the IPL for your engine.
Replace diaphragm part# 394
Clean screen Part# 393
Check ball & inlet Part# 913
OR buy new carb for about $27

    Bookmark   November 22, 2012 at 11:21AM
Thank you for reporting this comment. Undo
rustyj14(W/PA)

I'd try the gas cap vent hole first! Little bugs just love to drop an egg in those holes, and seal them up with goo!
And, if that fails, then go with Bill K's advice. Rustyj.

    Bookmark   November 22, 2012 at 5:24PM
Sign Up to comment
More Discussions
New Toro Push Mower?
I am looking to replace an 11 year old Toro Recycler,...
seashells18
Advice Needed on a Used Mclane Reel Mower
Hello! I live in Southern California (San Fernando...
hbcsc153
Engine trouble! B&S 13.5hp
My old Heritage ride-on has a Briggs& Stratton...
Over_here
need a mower
Hi. I'm trying to find a decent self propelled walk...
mjgarden1
Snapper 21 BBC Rehab complete! see pics
Guys, Finally after much effort I finished the Snapper...
quickrick
© 2015 Houzz Inc. Houzz® The new way to design your home™