Echo BLower will not start

wtcrain69January 11, 2010

I have an echo blower that was given to me and it will not start, I have rebuilt the carb. new plug, and fresh gas...it's drawing gas from the tank into the carb, but I don't think it's getting gas into the cyclinder. Does anyone have any suguestions?

Hope to hear back.

It's a Zama C1U carb...

Thanks

Thank you for reporting this comment. Undo
yungman

Have you verified no gas going to the cylinder? Take off the plug, close the choke and pull a few time, if you have gas, you should smell it from the spark plug hole. If not, you don't have gas.

If you have gas, check the spark.

    Bookmark   January 11, 2010 at 8:06PM
Thank you for reporting this comment. Undo
ewalk

If your not sure as to gas within the Combustion Chamber add a few drops of fuel or starting fluid into the spark plug hole then replace plug and try restarting , it should fire or run for a few seconds. If not you not getting any spark ! Ty .

    Bookmark   January 12, 2010 at 7:36AM
Sign Up to comment
More Discussions
Primer not getting Gas?? After Carb Rebuid?
I just rebuilt a couple snow blower Carbs (both Tecumseh...
bertman_gw
Have you successful cut any “seasoned firewood” inside?
Have you successful cut any “seasoned firewood”...
loger_gw
Snow Thrower impeller
I have a Craftsman 9 hp dual stage snow thrower, that...
fjs001
Snowblowers and engine choices - Ariens vs Toro vs Simplicity and
I live on the shoreline in CT, where we get anywhere...
bfguilford
Reciprocating Saw
I am looking to buy a reciprocating saw. I am not looking...
pirate94
© 2015 Houzz Inc. Houzz® The new way to design your home™