jd 726 engine problem

shirtguyFebruary 9, 2010

I must own the snowblower from hell. Today while going through 4 ft drift I hear clink very regularl. Then a cluck and it died. I hear the engine trying to start but nothing. Sounds like something inside the engine. Any suggestions. Piston rod maybe.

Thank you for reporting this comment. Undo
shirtguy

Got cylinder head off. When I cranked the engine the piston did not move. Rods were fine. I'm thinking its the connecting rod. How do I get to this? Thanks Bruce

    Bookmark   February 9, 2010 at 9:58PM
Thank you for reporting this comment. Undo
canguy(British Columbia)

Yup, the connecting rod has grenaded.What are the engine model and type numbers? You could remove and disassemble the engine but then what? Probably farther ahead to install a short block if available or a new engine.

    Bookmark   February 9, 2010 at 10:23PM
Thank you for reporting this comment. Undo
ewalk

CG : Sound like an another older Unit right ? Time for a China Clone ? lol !

    Bookmark   February 9, 2010 at 11:24PM
Sign Up to comment
More Discussions
Any Good Electric Brushcutter?
I have a small area, my lot is just 1/2ac and less...
InFlux
Electric shredder motor will switch on but won't spin the blades
Hello, I have an electric garden shredder that will...
Lindsay Durdle
Troy Bilt Horse Drive Shaft Bearings
I took my horse apart because the front transmission...
gildomilo
2 stroke Mantis tiller vs. 4 stroke Mantis
I'm looking at buying a small Mantis cultivator but...
lil_rhody
Primer not getting Gas?? After Carb Rebuid?
I just rebuilt a couple snow blower Carbs (both Tecumseh...
bertman_gw
© 2015 Houzz Inc. Houzz® The new way to design your home™