Briggs 7.5hp help with carb linkage

fespoFebruary 15, 2010

Hello all, I have a 7.5 Hp briggs Ohv(1501120408e)that blew a head gasket. I replaced that with no problem, the problem now is I can't get the carb/gov linkage set right. Anything I try, the engine will run FULL, WIDE OPEN. I don't know what I did or have to do, but i need help. Thanks fespo

Thank you for reporting this comment. Undo
chevyssrule

Good Morning,
I believe that is the code number the model number should have six digits & should be above or below the number you posted.
If you can find the model number I have a B&S repair manual that B&S sent me for free (it shows how all the carb/gov linkages are set) as I was having this problem with my 7.5Hp intek snow that I had bought for my 78 Toro snowblower.
Having said this if your is like mine as mine was doing the same as yours I found that I had to replace both springs that ran off the governor lever. My model number is 12D413
If you can find this number I'll look it up & send you the page from the service manual it tells & shows everything.

    Bookmark   February 22, 2010 at 8:07AM
Sign Up to comment
More Discussions
Are you finding Insert Pic Attachments to work as printed on this Site
Are you finding Insert Pic Attachments to work as printed...
loger_gw
What locked my Neighbor’s 6.5 Briggs Quantum Edge Engine?
I wanted to see what locked my Neighbor’s 6.5 Briggs...
loger_gw
Have you successful cut any “seasoned firewood” inside?
Have you successful cut any “seasoned firewood”...
loger_gw
Deep Spader
Has anyone used a deep spader? How did you like it?...
svachon
Looking for a new "top box" for my tool chest.
My old one died of old, old age and I didn't replace...
exmar
© 2015 Houzz Inc. Houzz® The new way to design your home™