A Poulan S-25 Automatic Oiler service tip that worked good

loger_gwFebruary 23, 2012

A Poulan S-25 Automatic Oiler service tip that worked good. If the auto oilier pump is not working due to possible debris in the pump it can be cleaned with a 1/16" drill bit. The service manual recommends marking the bit depth at 9/16" with tape and manually twist it into the diaphragm's pintle/shaft's port/hole c/w. Then pull out trash collected in the drill's flutes. I took it a step further knowing my auto oilier was not adequate oil vs the good manual oiling. I ran the bit in the bar oil's port-hole (by the bar) lightly as I turned the bit c/w until I felt light contact. Bingo! I started the saw w/o the bar and chain and got a good flow automatically as with the manual oilier.

Wire possibly would have cleared the port but I doubt as good as the bite's fluts. My question is, do you feel or know entering at the bar oil's port by the bar, is it possible to make contact with the diaphragm? Loger

Thank you for reporting this comment. Undo
tomplum

You've had some good posts over the winter Loger- keep up the good work!

    Bookmark   February 25, 2012 at 5:13PM
Sign Up to comment
More Discussions
Any Good Electric Brushcutter?
I have a small area, my lot is just 1/2ac and less...
InFlux
Older Troy Built Tiller Model ID
Trying to indentify model number of my unit. It is...
gardenerfrank
2 stroke Mantis tiller vs. 4 stroke Mantis
I'm looking at buying a small Mantis cultivator but...
lil_rhody
No more roll pins
Finally got the roll pins out of the wheels on my Horse...
snuffyinatl
Sears air compressor engine won't run when plugged in
Sears Paint Sprayer/Air Compressor Model No. 106.153542...
Cletus77
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™