troy bilt tiller trans

greenoeMarch 30, 2011

My troy bilt tiller is leaking around the shifting shaft on the back of the trans. Is it replaced from inside or outside of the trans?

Thank you for reporting this comment. Undo
gator_rider2(z8 Ga.)

Most time its pressure in transmission causing leak at shift shaft so no venting. The vent in looseness off plunger in transmission cover that valve looking spring hole engine up off backup disc air goes in and out by plunger my 2 troybilt plungers were frozen up and shifter shaft leaked after free plunger and adding transmission fluid leak stop and yes take shaft from inside to change seal. There way to make vent by taking T handle out go to grinder cut straight up grove in threads so vent by threads. You drill case cover tape female pipe thread add rear end vent to cover off car or pickup this takes more tooling.

    Bookmark   March 31, 2011 at 8:51AM
Sign Up to comment
More Discussions
Electric shredder motor will switch on but won't spin the blades
Hello, I have an electric garden shredder that will...
Lindsay Durdle
Is the attached a sign of Red Oak with a fungus, Etc and dangerou
Is the attached a sign of Red Oak with a fungus, Etc...
loger_gw
troy bilt horse question
Went to check the transmission fluid today and noticed...
snuffyinatl
Kohler K181 valve clearance
The engine would run perfect for maybe 30-45 minutes,...
snuffyinatl
Primer not getting Gas?? After Carb Rebuid?
I just rebuilt a couple snow blower Carbs (both Tecumseh...
bertman_gw
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™