Fiberglass tool handle splinters

who2ted(Z6/AZ)March 11, 2014

Anyone found a fix for garden rakes etc. that start getting tiny splinters? I don't always wear gloves or forget and then you get those pesky little splinters. Would painting help or coating with something?

Thank you for reporting this comment. Undo
loger_gw

I have used the black foam insulation tubes for insulating pipes from Home Depot or did it come on the rakes?? Schedule 20 PVC âÂÂmight fitâ with a few bolts/screws at extreme ends. Last, Duct Tape in favorite locations.

    Bookmark   March 11, 2014 at 11:37PM
Thank you for reporting this comment. Undo
tomplum

How about Plasti-Dip?

    Bookmark   March 15, 2014 at 11:55AM
Thank you for reporting this comment. Undo
who2ted(Z6/AZ)

Two good coats of spray enamel seems to have worked. We'll see how long that lasts.

    Bookmark   March 16, 2014 at 12:39AM
Sign Up to comment
More Discussions
Craftsman Snowblower Recall
Did anyone else receive a recall notice in the mail...
pjrsjr
Primer not getting Gas?? After Carb Rebuid?
I just rebuilt a couple snow blower Carbs (both Tecumseh...
bertman_gw
Stihl vs. Husqvarna Chainsaw purchase
I am lucky enough to have my wife ask me to pick out...
virginiacowboy
Predator 212cc Engine, Harbor Freight FYI
Hi Folks, Been thinking of getting one of these for...
exmar
2-cycle engine troubleshooting
My 2-cycle blower cannot be started. There is a hot...
slim50
© 2015 Houzz Inc. Houzz® The new way to design your home™