Devilbliss GB 5010 5000 watt generator

michael434445April 27, 2013

I have a 5010 generator that will not generate power....I took the back cover off...found 2 winding ends loose on the exciter...the other 2 windings on the other side are soldered to a bolt...do the other 2 windings connect on the other side/
Thank you very much
Mike

Thank you for reporting this comment. Undo
dwbdave

I am not sure which wires you are describing. Sounds like your two loose wires should connect to the "bridge rectifier", maybe it overheated and the two wires that appeared to be bolted down are actually connected to melted spade lugs. That's what happened to my GB5000, which may be very similar to your model. Colors of the wires and/or a picture would help if possible.

This post was edited by dwbdave on Sat, May 18, 13 at 18:48

    Bookmark   May 18, 2013 at 2:08PM
Sign Up to comment
More Discussions
Any Good Electric Brushcutter?
I have a small area, my lot is just 1/2ac and less...
InFlux
Craftsman Snow Blower - Drive problem
During our big storm last week i noticed I started...
rspin
Craftsman Snowblower Recall
Did anyone else receive a recall notice in the mail...
pjrsjr
Kohler K181 valve clearance
The engine would run perfect for maybe 30-45 minutes,...
snuffyinatl
Testing the new format X allowing multiple attachments.
I am back to two Lexan chain guides due to a chain...
loger_gw
© 2015 Houzz Inc. Houzz® The new way to design your home™