Troy-Bilt Chipper/shredder Belt

jdeerefordApril 27, 2009

Hi ladies and gentlemen. This is the first time that I have used a forum to glean information from other people with similar intrests. I have a Troy-Bilt chipper/shredder, pto driven, model # 47026. I have all the manuals for it and my othe Troy-bilt equipment. As most people know Troy-Bilt is gone but their equipment lives on. I need a belt for my chipper/shredder part # 1908749. I can't find a cross over for this double sided vee belt. I have not been able to find the specs of the belt either. I bought it new and have used it some but I let a friend use it and a large piece of wood jamed the cutter and burned the belt before the machine could be shut down. Needless to say nobody borrows a Troy-bilt of mine anymore. I use Troy all year long. In the winter it splits wood and spring through fall it tends a 1 acre garden with some help from my old John Deere. Thanks for any help with the belt problem and anyone needing copies of manuals, I have all of mine.

Thank you for reporting this comment. Undo
nod702(z7Tenn.)

I have several pieces of older Troy-bilt equipment and i've had good luck purchasing belts from Napa Auto Parts stores. The two stores in my area can cross referance the Troy-bilt number to a Napa number. In fact i just replaced the two belts on a Troy-bilt walk behind mower last week.

    Bookmark   April 27, 2009 at 8:33PM
Thank you for reporting this comment. Undo
johng_gardener(Zone 5)

I found belts for Troy-Bilt Chipper/shredder from JayDee
Enterprises Inc at www.jdv-belts.com I purchased belt
PIX-AA55 it's a double sided vee belt and it works fine. Off hand I don't know the price but their email addy is jdvbelts@earthlink.net Hope this helps you out.

    Bookmark   May 3, 2009 at 7:46PM
Thank you for reporting this comment. Undo
lawleck

I have a Trot Bilt Super Tomahawk chipper/shredder.
The question is what should the chipper knife clearance be. If someone could measure it and reply, I would be very grateful. The holes in the main shaft set the flail/chipper location and the old shaft was very bad.
This machine came to me with a bent main shaft and bad main shaft bearing. I had to cut the ends off the main shaft to get the flail assembly out of the machine. I have made a new shaft and it all looks good and should work well.
I am running 1 in shaft bearings on the new shaft and that should improve the life.
If anyone needs a shaft or other machine work done to extend the life of their machine pleas send an E Mail. I also have manuals and numerous sources for parts.
I make flails out of old truck springs and harden them.

    Bookmark   July 17, 2011 at 9:11PM
Sign Up to comment
More Discussions
Older Troy Built Tiller Model ID
Trying to indentify model number of my unit. It is...
gardenerfrank
Troy Bilt Pony Tiller
I have a Troy Bilt Pony Tiller with a 5 HP Briggs and...
beeer_2008
honda snowblower problem
i have a honda 928 snowblower... good machine, but...
rudall
IS it ME ? OR is this site/Forum Gone in hibernation?
This used to be such an informative and active site!!...
bertman_gw
Tecumseh snow king fuel starvation?
My Tecumseh powered Toro snowblower hunts/surges and...
akachrisinmass
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™