Craftsman Garage Door Opener Adjustment Issue

brians72April 26, 2009

Hello,

I have a Craftsman 1/2HP Garage door opener that is roughly 10 years old. I just replaced the main gear due to wear (the worm gear was fine). I hooked everything back up and used this forum (thanks Don) to it running again, but I am finding that when the door reaches the ground, it bows the track up just a bit. When I open it, it straightens out and opens, but when I close it it bows the whole track. I have played with the adjustments in the back but can't seem to find the right tweak that will get it to just come to a stop but not push the track up. Any ideas for me?

Thank you for reporting this comment. Undo
don_1_2006

The adjustment for this is on the side of the unit. Use a small screwdriver and turn the 'down limit' in the opposite direction of the arrow printed on the cover.

    Bookmark   April 27, 2009 at 10:18AM
Sign Up to comment
More Discussions
Troy Bilt Pony Tiller
I have a Troy Bilt Pony Tiller with a 5 HP Briggs and...
beeer_2008
Poulan Pro rear tine tiller, burnt valve??
I have a 6.5 Intec Briggs on my tiller, which is 10...
slowpoke_gardener
Stihl vs. Husqvarna Chainsaw purchase
I am lucky enough to have my wife ask me to pick out...
virginiacowboy
Electric shredder motor will switch on but won't spin the blades
Hello, I have an electric garden shredder that will...
Lindsay Durdle
Kohler K181 valve clearance
The engine would run perfect for maybe 30-45 minutes,...
snuffyinatl
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™