Delta DTH2450 Pressure Washer Problem

whitewater114May 28, 2011


I have a lightly used gas Delta DTH2450 pressure washer with Honda engine.

It ran perfectly for 7 years up until yesterday. Halfway through washing the deck, the high pressure would not work, to the point when you pull the trigger, no water exits the wand in high pressure mode. The unit sprays water in low pressure mode.

I checked the water inlet and house water pressure. Both are fine. No leaks from the washer itself.

I did some research and think it may be a stuck unloader valve.

I want to service it myself. Does anyone know where on the unit the unloader valve is located? Do I need to pull the engine to service the unloader valve or pump? Any recommendations on service related to this issue?

Any advice would be greatly appreciated.

Sign Up to comment
More Discussions
troy bilt horse question
Went to check the transmission fluid today and noticed...
Craftsman Snow Blower - Drive problem
During our big storm last week i noticed I started...
Toro 826 Drive Belt Jumps Off Crankshaft Pulley
Hello, I have a nine year old Toro Powermax 826. Late...
Poulan Pro rear tine tiller, burnt valve??
I have a 6.5 Intec Briggs on my tiller, which is 10...
Kohler K181 valve clearance
The engine would run perfect for maybe 30-45 minutes,...
© 2015 Houzz Inc. Houzz® The new way to design your home™