Troy Bilt Chipper RMS + Belt

blue_steel1May 15, 2010

I inherited a Troy Bilt Chipper Shredder, Model # 11390 w/ a B&S 8 HP motor.

1. It takes 5 or 6 attempts to engage the hammers, no matter how slow I move the clutch lever. I move the lever like honey in January and it still bogs down the engine and usually stalls. I have let the engine warm up for 3 or 4 minutes, the carb was rebuilt last summer, fuel is fresh, air filter is new... not sure what to do. Its designed to run at high rpms and there is no throttle adjustment. As the engine slows, it appears that the governor regulates the engine and increases rpms when there is load from the chipper. Any ideas / suggestions?

2. Anyone know the proper belt for this machine (generic is fine)?

Thanks.

Thank you for reporting this comment. Undo
blue_steel1

Sorry, I meant RPMs

    Bookmark   May 15, 2010 at 6:43PM
Sign Up to comment
More Discussions
Primer not getting Gas?? After Carb Rebuid?
I just rebuilt a couple snow blower Carbs (both Tecumseh...
bertman_gw
Older Troy Built Tiller Model ID
Trying to indentify model number of my unit. It is...
gardenerfrank
2 stroke Mantis tiller vs. 4 stroke Mantis
I'm looking at buying a small Mantis cultivator but...
lil_rhody
2-cycle engine troubleshooting
My 2-cycle blower cannot be started. There is a hot...
slim50
Electric shredder motor will switch on but won't spin the blades
Hello, I have an electric garden shredder that will...
Lindsay Durdle
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™