Troy horse tiller transmission

gampopaMay 22, 2010

I have a '85 Troy bilt tiller model # 195432 which needed to have the main power shaft replaced. I was able to disassemble the transmission and order new parts. On the new drive shaft the bearing and cup nearest the worm is already mounted. There is another bearing and cup that needs to be mounted but I'm not sure how to do it w/o damaging it because the shaft widerns slightly where the bearing rests. I suspect this is where the bearing locks into place on the shaft but how do you get it on there?

Thank you for reporting this comment. Undo
mla2ofus

With the OK of the "BOSS", Put the bearing in the oven @ 400* put the shaft in the chest freezer if you have one for a couple of hours. Hold brg w/ a heavy leather glove and slip it on the shaft immediately after taking both out of their respective heating/ chilling areas.
Mike

    Bookmark   May 22, 2010 at 10:23PM
Sign Up to comment
More Discussions
What locked my Neighbor’s 6.5 Briggs Quantum Edge Engine?
I wanted to see what locked my Neighbor’s 6.5 Briggs...
loger_gw
Woodzig electric pruner
I have a Woodzig electric pruner and use it often....
ranger_ric
Garage Door Opener Repair tips PT1 long
Hi all, it seems to me that in general GDO posters...
techdave
Harbor Freight small utility tralier question
I just purchased this harbor freight trailer. http://www.harborfreight.com/1090-lb-capacity-40-1-2-half-inch-x-48-inch-mini-utility-trailer-with-12-inch-four-lug-wheels-and-tires-90153.html I...
rlmunsey
Have you successful cut any “seasoned firewood” inside?
Have you successful cut any “seasoned firewood”...
loger_gw
© 2015 Houzz Inc. Houzz® The new way to design your home™