sears garage door opener not working

mbrownoneMay 1, 2013

Hi, new to this forum and welcome some advice about my earlier sears garage opener model 139.535.

Replaced worn drive gear which was fairly simple and straight forward. But now none of the remotes or wall mounted button works unless I disconnect the small white "lego-like piece" in front of the electric motor. It appears to have 5 or so pins which slide into it. Obviously it was connected before, but nothing happens when it is together and wall button is pressed. I didn't allow the motor to run long before pressing the button again to stop the chain from moving. Can someone tell me what is happening? How can I correct this? I've been double cheching wire connections and everything appears to be where it was when everything was fine (before the drive gear teeth wearing out). Thanks for any advice....

Thank you for reporting this comment. Undo
loger_gw

Please show a Pic or link to the matter or part that you are describing. I have 2-3 Sears OpenâÂÂs manuals IâÂÂll check the trouble shooting section when I see your ref..

    Bookmark   May 2, 2013 at 10:03AM
Sign Up to comment
More Discussions
Craftsman Snowblower Recall
Did anyone else receive a recall notice in the mail...
pjrsjr
2-cycle engine troubleshooting
My 2-cycle blower cannot be started. There is a hot...
slim50
Kohler K181 valve clearance
The engine would run perfect for maybe 30-45 minutes,...
snuffyinatl
Chainsaw:Poulan 295 Pro
I just purchased a used Poulan 295 Pro...$50..not bad!...
JDH2015
Troy Bilt Horse Drive Shaft Bearings
I took my horse apart because the front transmission...
gildomilo
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™