2150 poulan chain saw

jeffchapJune 7, 2013

My poulan 2150 will not start. OK here goes with things I have done. I have replaced 3 coils and all the fuel lines. Rebuilt carb. Replaced ground and kill wires. I have tried air gap at 25 and 15. Compression checks at 120psi. This unit will not fire with starting fluid. I have replaced 3 spark plugs and set gap at 25. I have watched flywheel and air gap clearance for possible bent crankshaft. I have an identical 2150 that I have rebuilt and it runs fine. I am about to start swapping parts from it. Is there a reed valve that I am overlooking? Anyone up for solving this problem?

Thank you for reporting this comment. Undo
ggoyeneche

No reed valve in your engine. It is piston ported.

    Bookmark   June 8, 2013 at 3:54PM
Sign Up to comment
More Discussions
Older Troy Built Tiller Model ID
Trying to indentify model number of my unit. It is...
gardenerfrank
Tecumseh snow king fuel starvation?
My Tecumseh powered Toro snowblower hunts/surges and...
akachrisinmass
Reciprocating Saw
I am looking to buy a reciprocating saw. I am not looking...
pirate94
2-cycle engine troubleshooting
My 2-cycle blower cannot be started. There is a hot...
slim50
Electric shredder motor will switch on but won't spin the blades
Hello, I have an electric garden shredder that will...
Lindsay Durdle
© 2015 Houzz Inc. Houzz® The new way to design your home™