ryobi weed wacker

lizzieboxerJune 5, 2010

I have a gas Ryobi weed wacker. The actual trimmer connection, when snapped into the upper part, does not turn properly. Sometimes the trimmer works...then other times it just slows completely down. It is getting gas, the motor is running fine. It seems that the trimmer connection is not seating properly in the motor part. I thought that perhaps a new trimmer connection would remedy the problem but it has not. The new trimmer head does not spin properly either. Any suggestions?

Thank you for reporting this comment. Undo
canguy(British Columbia)

The cable in the lower section may be stripped at the end where it engages the upper shaft. Can you post the model number? There were two manufacturers of these units.

    Bookmark   June 5, 2010 at 12:36PM
Sign Up to comment
More Discussions
Kohler K181 valve clearance
The engine would run perfect for maybe 30-45 minutes,...
snuffyinatl
Sears air compressor engine won't run when plugged in
Sears Paint Sprayer/Air Compressor Model No. 106.153542...
Cletus77
IS it ME ? OR is this site/Forum Gone in hibernation?
This used to be such an informative and active site!!...
bertman_gw
Testing the new format X allowing multiple attachments.
I am back to two Lexan chain guides due to a chain...
loger_gw
2 stroke Mantis tiller vs. 4 stroke Mantis
I'm looking at buying a small Mantis cultivator but...
lil_rhody
© 2015 Houzz Inc. Houzz® The new way to design your home™