Troy-Bilt Plastic gas tank fitting

larryk2010(3)June 6, 2010

My old, mid 80's, tiller has a bad rubber "gasket" on the plastic gas tank for the fuel fitting. I have searched and can not find a suitable parts list.

The tiller is a 6hp Horse with a Tecumseh HH60-105115H engine.

Any help would be appreciated.

Thanks,

Larry

Thank you for reporting this comment. Undo
baymee(LehighValleyPA)

http://www.outdoordistributors.com/pdf/Tecumseh/TECUMSEH-MODEL-HH60-105115H-PARTS-LIST.pdf

Try that.

    Bookmark   June 6, 2010 at 4:45PM
Thank you for reporting this comment. Undo
larryk2010(3)

I had looked there and that does not appear to be the same tank and fitting installed on the Troy-Bilt Horse.

The plastic tank has a rubber like "grommet" through which an angled brass fitting with filter screen is inserted.

I need that rubber or similar "grommet".

Thanks for your response baymee.

Larry

    Bookmark   June 6, 2010 at 10:43PM
Thank you for reporting this comment. Undo
baymee(LehighValleyPA)

125-336 Stens number Fuel tank bushing

1738433 Old Troy number / 935-0149 MTD number

cost about $2.50

    Bookmark   June 7, 2010 at 6:32AM
Thank you for reporting this comment. Undo
larryk2010(3)

Thanks baymee.

    Bookmark   June 7, 2010 at 6:49AM
Sign Up to comment
More Discussions
Troy Bilt Pony Tiller
I have a Troy Bilt Pony Tiller with a 5 HP Briggs and...
beeer_2008
2 stroke Mantis tiller vs. 4 stroke Mantis
I'm looking at buying a small Mantis cultivator but...
lil_rhody
Snow Thrower impeller
I have a Craftsman 9 hp dual stage snow thrower, that...
fjs001
Troy Bilt Horse Drive Shaft Bearings
I took my horse apart because the front transmission...
gildomilo
Primer not getting Gas?? After Carb Rebuid?
I just rebuilt a couple snow blower Carbs (both Tecumseh...
bertman_gw
© 2015 Houzz Inc. Houzz® The new way to design your home™