Chain Saw trouble

zauggsterJune 10, 2010

I have a Husqvarna 41 chain saw. It has the following behavior: If I get it out, set the choke, pull a couple of times, it fires. Push in the choke, pull the cord, it will run just fine. Cut things, all is well, it can be stopped and restarted instantly, until most of a tank of gas is gone. Then it dies. At that point I can hear what sounds like boiling gasoline, a fizzling noise. It will then start with the throttle all the way open, as if it were flooded, but it will only run for 2 seconds, then die. If I pull it once with the choke on, and then do the throttle wide open, it will rev for 2 seconds again. I have seen on this forum great advice. Have any of you some great advice for me? Thanks

Thank you for reporting this comment. Undo
codger01

What you describe could be a "vaporlock", has not been
a comon problem for some yrs. Take it to a high press.
air hose, blow all vents cleen, Oily sawdust dose not
cool very well!
Later ,, codger "al >

    Bookmark   June 11, 2010 at 12:23AM
Sign Up to comment
More Discussions
Is the attached a sign of Red Oak with a fungus, Etc and dangerou
Is the attached a sign of Red Oak with a fungus, Etc...
loger_gw
Predator 212cc Engine, Harbor Freight FYI
Hi Folks, Been thinking of getting one of these for...
exmar
Smoky 8 horse Kohler
I recently got an old Troy Bilt Horse with the K181...
snuffyinatl
2 stroke Mantis tiller vs. 4 stroke Mantis
I'm looking at buying a small Mantis cultivator but...
lil_rhody
Electric shredder motor will switch on but won't spin the blades
Hello, I have an electric garden shredder that will...
Lindsay Durdle
© 2015 Houzz Inc. Houzz® The new way to design your home™