presser washer Tecumseh float bowl attach

mvronJuly 16, 2011

I have a coleman vantage Tecumseh 3.5 vantage model TVS90 43739M pressure washer. I removed the float bowl to clean the main jet and can't get the main jet to reattach/rethread into the engine. It's driving me crazy. I removed it but can't get it back on. I twisted the float bowl different directions - that didn't help.

Any ideas before I take it to the dump?

Thank you for reporting this comment. Undo
rustyj14(W/PA)

Are you turning the bowl bolt the correct way, to install the bowl? Remember: "Lefty-loosey/ Righty tighty"!

    Bookmark   July 16, 2011 at 9:00PM
Thank you for reporting this comment. Undo
mvron

Absolutely. The bowl seems level - I've done this many times on other units - dosen't make any sense. I threaded the bolt directly to the unit without the bowl and it fastens securly - so I know the threads are OK. thanks..

    Bookmark   July 17, 2011 at 9:12AM
Sign Up to comment
More Discussions
Primer not getting Gas?? After Carb Rebuid?
I just rebuilt a couple snow blower Carbs (both Tecumseh...
bertman_gw
Snow Thrower impeller
I have a Craftsman 9 hp dual stage snow thrower, that...
fjs001
Toro 826 Drive Belt Jumps Off Crankshaft Pulley
Hello, I have a nine year old Toro Powermax 826. Late...
ronpr2112
Reciprocating Saw
I am looking to buy a reciprocating saw. I am not looking...
pirate94
2 stroke Mantis tiller vs. 4 stroke Mantis
I'm looking at buying a small Mantis cultivator but...
lil_rhody
© 2015 Houzz Inc. Houzz® The new way to design your home™