Garden Way Tiller

lippy00July 19, 2010

I have a old garden way rear tine tiller there are no model or serial # that I can find. The question that I have is the tines will swing about 15 degrees right or left is this the way it should be? It looks like someone tried to tack weld it into place but it broke loose, can anyone give me any information.

Thank you for reporting this comment. Undo
baymee(LehighValleyPA)

Explain a little better. Is it a PTO model with a lever on the left side "engage and Disengage tines"

    Bookmark   July 19, 2010 at 8:03PM
Thank you for reporting this comment. Undo
lippy00

No. It has cable and a lever to engage the drive for the wheels, the tines are connected with a round tube from the gear case and it swivels at the gear case, I haven't taken it apart to see if there is anything broken it does not seem it should be loose.

    Bookmark   July 26, 2010 at 6:52PM
Sign Up to comment
More Discussions
Troy Bilt Horse Drive Shaft Bearings
I took my horse apart because the front transmission...
gildomilo
2-cycle engine troubleshooting
My 2-cycle blower cannot be started. There is a hot...
slim50
Sears air compressor engine won't run when plugged in
Sears Paint Sprayer/Air Compressor Model No. 106.153542...
Cletus77
Predator 212cc Engine, Harbor Freight FYI
Hi Folks, Been thinking of getting one of these for...
exmar
Electric shredder motor will switch on but won't spin the blades
Hello, I have an electric garden shredder that will...
Lindsay Durdle
© 2015 Houzz Inc. Houzz® The new way to design your home™