Husqvarna 435 chain saw

dmgray55(6b)July 18, 2010

I was changing the chain on my Husqvarna 435 chain saw. When I removed the cover a black washer fell out but I couldn't tell where it came from of where it goes. The manual calls it a transportation ring but gives no information about it. The chain will not move on the bar so I am assumong it has something to do with this ring. Anyone have the same issue?


Thank you for reporting this comment. Undo

Guess nobody knows...I can't even get Husqvarna to answer

    Bookmark   July 28, 2010 at 8:27PM
Thank you for reporting this comment. Undo
masiman(z7 VA)

If you can get the IPL for your saw you may be able to track down where it may have come from.

Sometimes there are washers on the driveshaft for the sprocket, but that won't come off unless the sprocket can come off.

I'm guessing that the washer fell in there and is not part of your saws assembly.

    Bookmark   July 28, 2010 at 9:04PM
Thank you for reporting this comment. Undo

Is the chain brake on? Steve

    Bookmark   July 30, 2010 at 12:44PM
Sign Up to comment
More Discussions
Have you successful cut any “seasoned firewood” inside?
Have you successful cut any “seasoned firewood”...
Building storage shed on a terraced slope
Is it safe to build a storage shed occupying two levels...
Thomas Lu
What’s a good safe cure to stop or slow root entering sewer line?
What’s a good safe cure to stop or slow root entering...
Harbor Freight small utility tralier question
I just purchased this harbor freight trailer. I...
New Ryobi S430 engine dies on full throttle
Just bought a new Ryobi straight shaft 4 Cycle S430...
Sponsored Products
Husqvarna 580BTS 75.6cc Backpack Blower Yard Care Tool
Husqvarna '130BT' 2-cycle 29.5cc Black/ Orange Backpack Blower
© 2015 Houzz Inc. Houzz® The new way to design your home™