Troy-bilt Bush cutter

olddawg(5)September 19, 2010

I'm not impressed with the blade that comes with the attachment.

Anyone know of an aftermarket blade?

Prefer metal so I can take down some of these 3" saplings.

Thank you in advance

Thank you for reporting this comment. Undo
masiman(z7 VA)

I'm not sure how strong the Troy Bilt model is. It may not be designed for heavier brush applications. However that does not mean you can't do it. Check if Troy Bilt recommends any type of blade. If they explicitly say not to or don't mention it then, I'd try the smallest lightest blade you can find. There are some three blade units out that look fairly light. Take it slow and easy and you should be okay. If your unit has a flexible shaft it is likely less able to handle brush cutting. Typically solid shafts are used when brush cutting is an intended purpose. With that said, I use my flexible shaft a couple times a year for the last 4 years doing brush cutting.

    Bookmark   September 27, 2010 at 6:58PM
Sign Up to comment
More Discussions
2-cycle engine troubleshooting
My 2-cycle blower cannot be started. There is a hot...
slim50
Dewalt 3800 pressure washer, open hole between pump and engine.
Hi, I just bought a dewalt 3800 pressure washer gx...
ron111
Best gas leaf blower?
Can anyone recommend a good gas powered leaf blower?...
robar
Older Troy Built Tiller Model ID
Trying to indentify model number of my unit. It is...
gardenerfrank
Craftsman Snow Blower - Drive problem
During our big storm last week i noticed I started...
rspin
© 2015 Houzz Inc. Houzz® The new way to design your home™