Troybilt super tomahawk bolt size

mtnfrmrOctober 25, 2011

Can anyone help me with the correct bolt size that fits into the driveshaft of a TroyBilt Super Tomahawk #15014? This is the bolt that holds the driveshaft on the chipper side of the unit.

Thru a series of missteps, I have lost the original bolt.

Thank you for reporting this comment. Undo
ericwi

This is likely to be a high strength bolt, and it should be marked as such on the head. It might be best to get a replacement directly from the TroyBilt factory.

    Bookmark   October 26, 2011 at 12:27PM
Sign Up to comment
More Discussions
troy bilt horse question
Went to check the transmission fluid today and noticed...
snuffyinatl
Troy Bilt Horse Drive Shaft Bearings
I took my horse apart because the front transmission...
gildomilo
Dewalt 3800 pressure washer, open hole between pump and engine.
Hi, I just bought a dewalt 3800 pressure washer gx...
ron111
Toro 826 Drive Belt Jumps Off Crankshaft Pulley
Hello, I have a nine year old Toro Powermax 826. Late...
ronpr2112
Kohler K181 valve clearance
The engine would run perfect for maybe 30-45 minutes,...
snuffyinatl
© 2015 Houzz Inc. Houzz® The new way to design your home™