Troy bilt tiller

carolinaslimOctober 16, 2010

I have a horse model and it seems the dogs are worn short, has anyone else experienced this problem? The transmission dog turns with the engine and the tine dog turns with the tines but when bolted together the tines will not turn, help. Only thing I know to do is install new dogs, is there something else I could try?

Thank you for reporting this comment. Undo
gator_rider2(z8 Ga.)

Slim other post I think answer in that post take back apart check weld on dog.

    Bookmark   October 16, 2010 at 8:01PM
Thank you for reporting this comment. Undo
mla2ofus

Is the trans dog sliding all the way out against the retaining ring on the output shaft? If yours is the PTO model it should have plenty of grease packed in there w/ the dogs.

Mike

    Bookmark   October 17, 2010 at 4:58PM
Thank you for reporting this comment. Undo
carolinaslim

I have a horse model and it seems the dogs are worn short, has anyone else experienced this problem? The transmission dog turns with the engine and the tine dog turns with the tines but when bolted together the tines will not turn, help. Only thing I know to do is install new dogs, is there a way to check the dogs for wear or something else I could try?

    Bookmark   October 23, 2010 at 4:15PM
Thank you for reporting this comment. Undo
mla2ofus

Did you check what we suggested?
Mike

    Bookmark   October 24, 2010 at 4:54PM
Thank you for reporting this comment. Undo
carolinaslim

I have checked all of the above, welds are solid, dog all the way out and plenty of grease.

    Bookmark   October 27, 2010 at 7:59PM
Thank you for reporting this comment. Undo
mla2ofus

If they're worn there should be evidence of wear on the faces where they engage ie: the corners will be rounded instead of square.
Mike

    Bookmark   October 29, 2010 at 7:54AM
Sign Up to comment
More Discussions
Craftsman Snowblower Recall
Did anyone else receive a recall notice in the mail...
pjrsjr
Snow Thrower impeller
I have a Craftsman 9 hp dual stage snow thrower, that...
fjs001
Kohler K181 valve clearance
The engine would run perfect for maybe 30-45 minutes,...
snuffyinatl
Electrolytic Rust Removal
Has anyone tried this, using a battery charger, "washing...
exmar
Toro 826 Drive Belt Jumps Off Crankshaft Pulley
Hello, I have a nine year old Toro Powermax 826. Late...
ronpr2112
© 2015 Houzz Inc. Houzz® The new way to design your home™