Why is this post reported as an error?

loger_gwOctober 8, 2011

Why is this post reported as an error?

Is the "Husqvarna 51 Chainsaw Overheat" the most recent Husqvarna Chainsaw post vs one that was discovered to have a bad cyl through the plug's hole (maybe yesterday)? The saw had given 15 yrs of family service. There were parts and new saw cost info, along with an interest of a STIHL replacement. Was this post pulled for some reason or where is it?

Can you see enough through the plug's hole w/o a camera to make a good diagnosis vs removing the 2 cycle's muffler and inspecting through the exhaust port? loger

Thank you for reporting this comment. Undo

I apologize for this investigation and that it is still top of the list since there were no replies. loger

    Bookmark   October 24, 2011 at 3:06PM
Thank you for reporting this comment. Undo

I don't think you will see much thru the spark plug hole, but you might see more thru the exhaust port!

    Bookmark   October 24, 2011 at 4:15PM
Thank you for reporting this comment. Undo

Thanks Rusty, Maybe the post will move down as others. My real concern was getting back to a post I "Thought I Spotted" related to a wrist pin ruining a cyl. It's Time to Move On! This Nice North, TX Weather is allowing me to get back to some relevant projects and cleaning out non relevant projects. "Time Waits For No One". Enough Said! Loger

    Bookmark   October 24, 2011 at 4:44PM
Sign Up to comment
More Discussions
Predator 212cc Engine, Harbor Freight FYI
Hi Folks, Been thinking of getting one of these for...
Older Troy Built Tiller Model ID
Trying to indentify model number of my unit. It is...
IS it ME ? OR is this site/Forum Gone in hibernation?
This used to be such an informative and active site!!...
troy bilt horse question
Went to check the transmission fluid today and noticed...
Poulan Pro rear tine tiller, burnt valve??
I have a 6.5 Intec Briggs on my tiller, which is 10...
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™