Help with converting sprinklers to drip/bubbler sprayer system

sprtsguy76(Santa Clara Ca. 9b)March 16, 2012

Hi all. I have a single valve sprinkler system in my backyard. It has 8 sprinkler heads. I have capped off 4 of them and the other four I'm converting to 1/2 inch risers for drip/bubblers. Off these 4 risers I plan to run 1/2 inch poly tube with 10-15 adjustable bubblers/sprayers per line. These bubblers/sprayers supposedly have an adjustable flow rate of 0-18 GPH. So the question is: em I dreaming here or can this work?? I have not measured my water pressure in the backyard but I'm pretty sure its darn good. Any help would be greatly appreciated, thanks!

Damon

Thank you for reporting this comment. Undo
twolips(z6AZ)

You will need to check your pressure, if it's too high, it will blow your bubblers out of the poly. But yes, it can be done, using a Female Pipe Thread swivel fitting, in the size of your poly tubing. Most common being .700. Drip irrigation should be around 25 psi. You might get by with a little more tho.

    Bookmark   March 17, 2012 at 9:21AM
Sign Up to comment
More Discussions
Rain Bird SMRT-Y Moisture Sensor
I'm looking to connect a Rain Bird SMRT-Y Moisture...
cdmanoise
Sprinkler to Soaker Hose/Drip System
My project to convert an existing sprinkler zone to...
mixdplate
Problem valve
Hi, I have got a problem with my newly installed irrigation...
cozbell93
Best well pump for drip hose irrigation
I am trying to find some information on selecting a...
srbasile
Irrigation Outage
Had a power outage at my home. I reset the GFI switch...
mchidiac
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™