Need Help to ID valve model.

yesiam8833April 30, 2011

Any help would be great in helping me identify the valve model. I need to find a replacement for the diaphragm.

See the attached link called valve.

Thanks

Here is a link that might be useful: valve

Thank you for reporting this comment. Undo
lehua49

Yes,

If you don't know where they came from or see a label, then I would replace the valve manifold and valves. Start over. It is not that expensive and less effort on your part. JMHO Aloha

    Bookmark   May 2, 2011 at 8:22PM
Thank you for reporting this comment. Undo
yesiam8833

Thanks,

I found out it is an olson. The part will cost me about $14. I order the part and most likely replace the whole system comes winter. Thanks again.

    Bookmark   May 3, 2011 at 10:49AM
Sign Up to comment
More Discussions
sprinkler selection question
I'm doing some sprinkler maintenance and replacement...
donkeypebbles
Pulling water from creek for irrigation.
I have a home on a piece of property that has a stream....
mctabish1
Greenhouse irrigation advice
We are planning to build a 13'x'30' greenhouse in the...
rogerius
Making changes of existing irrigation system
Hi folks, am hoping you can help me with these questions. I...
lauriec
Avocado tree, brown on tip of leaves
The leaves on my avocado tree are turning brown. They...
dooger2
© 2015 Houzz Inc. Houzz® The new way to design your home™