grage door opener code

jacob904November 20, 2009

I have a genie intellicode garge door opener i want to change my keypad code but i don't know how to it has a program button what do i do?

Thank you for reporting this comment. Undo
jdhad

Go to their internet site as I did and get the instructions.
They are hard to follow but after several tries I got it to work. Good Luck

    Bookmark   November 20, 2009 at 1:17PM
Thank you for reporting this comment. Undo
don_1_2006

This is straight from Genie.

Step-By-Step Programming Procedure

  1. Reset Keypad--slide keypad cover half way up. While pressing the # and 8 buttons simultaneously, slide the Keypad Cover the rest of the way up until it latches. Release # and 8 buttons. At this point, if the back lit keypad light stays on, proceed directly to step 2. If the back lit keypad light goes out, close the cover pad and reopen it until it clicks. Proceed to step 2.
  2. Press 3, 5, 7 and # buttons in said order.
  3. Enter your PIN and press the # button. Your PIN number can be created from any group of numbers up to 8 digits of your choice. Note: Do NOT use"#" or "star" key.
  4. Enter Door Code, as determined from the chart at left, and press the "star" key.
  5. Slide Keypad Cover down.
  6. Test Keypad by sliding cover up until it latches. Enter your PIN and Press "star" key. Your door should operate.
    Bookmark   November 20, 2009 at 4:53PM
Sign Up to comment
More Discussions
Temperature alarm app for Android?
I am wondering if anyone knows of an Android app that...
armbarangel
cultivator or tiller or both
In the past I've manually tilled and cultivated my...
Bushwhacker Blood
Mantis Tiller purge bulb
I cannot get gasoline to come into the purge bulb....
Alice40
New Ryobi S430 engine dies on full throttle
Just bought a new Ryobi straight shaft 4 Cycle S430...
losrubios
Disgusted with my Mantis tiller
I've had a Mantis tiller since Spring of 2005. It's...
mitchb2
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™