Toro 824 Snowblower Belt Replacement

dhawk01December 21, 2013

Hi,

I have a 1992 Toro 824 snowblower (Model: 38080 SN: 2001223)

I need to replace the auger belt. While I'm there, I'm going to replace the drive belt as well.

Does anyone know if I have to split the case to do this? I haven't taken a close look at it yet.

Any help would be greatly appreciated!

Thanks!

Dave

Thank you for reporting this comment. Undo
gator_rider2(z8 Ga.)

You do not have to take off the impeller & auger. You just have to "split" the tractor half from the bucket (or scoop).
You do need a way to hold up the handle bars so they don't fall to the floor. 4 bolts.

    Bookmark   December 24, 2013 at 12:29PM
Thank you for reporting this comment. Undo
tomplum

I don't remember splitting these to do belts. With the cover off, you should see if there is room between the pulleys. If you put your model in Toro's parts look up, then look under the manual tab - there should be a free service manual.

    Bookmark   December 24, 2013 at 4:39PM
Sign Up to comment
More Discussions
Dewalt 3800 pressure washer, open hole between pump and engine.
Hi, I just bought a dewalt 3800 pressure washer gx...
ron111
Electrolytic Rust Removal
Has anyone tried this, using a battery charger, "washing...
exmar
Older Troy Built Tiller Model ID
Trying to indentify model number of my unit. It is...
gardenerfrank
Craftsman Snow Blower - Drive problem
During our big storm last week i noticed I started...
rspin
Stihl vs. Husqvarna Chainsaw purchase
I am lucky enough to have my wife ask me to pick out...
virginiacowboy
© 2015 Houzz Inc. Houzz® The new way to design your home™