Stihl HS-80 trimmern primer bulb

LALADecember 25, 2010

How do I replace a primer buld on a Stihl HS-80 trimmer.

I can not get to one of the little screws, it is behind the orange plastic part that the throtle cable is attached.

I am not sure how to remove the orange part or is there another trick I am missing?

Thank you for reporting this comment. Undo

Take out the air filter and take a 5/16" nutdriver and
remove the two nuts and pull the carb out to access the


    Bookmark   December 27, 2010 at 11:00PM
Sign Up to comment
More Discussions
Building storage shed on a terraced slope
Is it safe to build a storage shed occupying two levels...
Thomas Lu
Harbor Freight small utility tralier question
I just purchased this harbor freight trailer. I...
honda snowblower problem
i have a honda 928 snowblower... good machine, but...
General craftsman tiller gearbox question.
Ages ago in the early 90's, I bought a Craftsman 5hp...
New Ryobi S430 engine dies on full throttle
Just bought a new Ryobi straight shaft 4 Cycle S430...
Sponsored Products
Brushed Nickel Bath 3-Light Halogen
Quoizel Stephen TF885CVB Pendant - TF885CVB
$269.99 | Hayneedle
Marset | Atlas Pendant
$243.00 | YLighting
Woodbridge Bath and Vanity
Diamante 4-light Pendant
Black with Gold Trim Lamp Shade 3x6x5 (Clip-On)
$12.99 | Lamps Plus
Designers Fountain 96902 Montego 2 Light Bath Bar in oil-rubbed bronze finish -
$60.80 | Hayneedle
32" Infinite Wide 80/20 Offset Double-Bowl Stainless Steel Undermount Sink
Signature Hardware
© 2015 Houzz Inc. Houzz® The new way to design your home™