2011 Craftsman LT 2000

EclipserocksyouJuly 28, 2014

When I went to start my rider it wouldnt crank. There is no power coming out of relay next to battery. No power going to small wires. Ignition switch seems to energize. Jumped starter and spins but not engage. No power to seat switch. I think solenoid and switch must be ok because they arent even getting ignition voltage to them. The two red wired are hot coming out of switch when turned on. Any ideas?

Thank you for reporting this comment. Undo
bill_kapaun

Most seat switches shouldn't have power to them, but some do.
Post the Sears 917.xxxxxx number so one can look at the correct schematic out of the hundreds of them for Sears tractors.

"Small wires" doesn't mean anything without know WHICH ONES.

Not sure what you mean by ignition switch "energizing"?

    Bookmark   July 28, 2014 at 12:57PM
Sign Up to comment
More Discussions
Snapper Riding Lawn Mower Wiring Diagram
I'm trying to find a wiring diagram for a Snapper Rear...
byrondallas
Briggs & Stratton OHV Intek Hard Starting
I am another of the seemingly many people fighting...
dreamoftheflood
Tuff Torq K46 Tranny
I've been reading many of the posts on this site and...
tuco
What happened???
I logged in yesterday after a prolonged absence and...
romore_gw
transmission clean and do not overwork
I have a Dumb question about that phrase. Exactly what...
krnuttle
© 2015 Houzz Inc. Houzz® The new way to design your home™