|
| Hi,
I have an azalea bonsai about 3-4 years old in training. I have styled it to look like a multi-trunk Magnolia. It flowered about one week ago and lasted until Friday April 30th when I cut all the flowers off. I know how to prune the flowers. What I don't know how to do is prune the branches. I have a few unruly long branches. I need to cut them back to match the crown. I don't want to kill the branch. All of the leaves are at the tips of the branches where the flowers were. How do I do this? Thank you, Gardener Guy |
Follow-Up Postings:
|
| Hi, a picture would definitely be in order here as it's so particular to what you're asking about. I also wonder if your tree's had enough sun, or enough to have reached the lower parts of branches especially if you got it from e.g. the supermarket because they tend to encourage so much foliage on those the interior never gets enough, plus they're stuck indoors for long periods. Azaleas do better in light shade when outside, but not if they don't have some sun for a lot of the day. "Long and unruly" is a clue too - the flowers and leaves were reaching for more light. I don't know why you cut off the flowers - usually pruning is done after they fade, but when it happens naturally (the energy you may have thought you were saving was already spent by the time you cut them). In any case, why not try cutting a couple of branches and see what happens. If you like it, do the rest (or whichever ones suit your design). |
|
- Posted by head_cutter Vietnam (My Page) on Sun, May 2, 10 at 19:42
| Azalea pruning is no big deal, norally the dead blossoms are pinched rather than cut though. This is known as 'deadheading' and encourages bud-set for the future. A few seasons of this can lead to a plant/tree producing such a profusion of flowers that there is almost no foliage to be seen during blooming. During pruning it's best to clean out the smaller interior and crossing branches at that time, allowing more light in. The best way is to cut back a little further than you would think because it will force budding and breaks at the branch apex thus, more foliage. Normally you would look for latent buds and make the cut at a 45 degree angle, just a little ahead of the bud. Bob |
|
- Posted by gardener_guy (My Page) on Mon, May 3, 10 at 7:16
| Here is a picture of the azalea. I the left side is the area where the main branch needing trimming. others need trimming as well. This is directly after bloom. |
Here is a link that might be useful: Azalea Bonsai
|
- Posted by head_cutter Vietnam (My Page) on Mon, May 3, 10 at 21:25
| Looks like it's off to a pretty good start. Remember that Bonsai is about creating an illusion of age and size therefore the design is all about the 'proportions' of the plant/tree. Trunk size vs. heigth vs. canopy size and density among other things. The best time to prune them is after blooming, that is to 'chase' back the branches. This will lead to better overall density in the canopy. Azaleas can be cut very hard as long as they are in good health. There is no problem cutting the branches back even half way. This will give more breaks, buds every year for a few years until the canopy is nice and full. If you look at pics of them when being shown they are normally in bloom. Ones which have been styled right over the years will show 90% flowers and 10% or less foliage. They are quite a showy tree for Bonsai. Bob |
|
| Azalea back bud really well. You can cut all foliage off of a branch and it'll create (often) a new bud. If you look closely you may be able to see some rings (faint rings) from past year's growth. If you clip right above that, a new but should pop out. Prune after flowering. Also, a standard practice is to prune each branch after blooming to two branches / two leaves. HTH, |
Here is a link that might be useful: Satsuki 'Two Leaf / Two Branch' technique
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Bonsai Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.