|
Fri, Apr 6, 12 at 16:53
| Have a Honda lawn mower ( harmony II HHR 216 , OHC).
I had the control cable came loose and took it a part to clean and now it will not accelerate, it dies if I try to push the throttle stick forward. I took it apart 5 times and it only goes one way but it still act like choke is on and dies, I know I have it back together right and it did do this ( alittle) before I took it apart. Any ideas of what to destroy next???---helping advice only Jim-oe |
Follow-Up Postings:
|
| When you push the cable forward, it should close the choke when it is at the very end of the push. There should be a clamp that you can loosen, which holds the outer side of the cable in place. Loosen that clamp and the cable will tend to spring back to approximately where it should be. Fine tune from there. You clamp at the place where when you take the choke off, you'll hear a click and the choke will be fully off. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Lawn Mowers Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.