|
Tue, May 15, 12 at 12:11
| Hello. Is there any special trick or procedure to replace the upper and lower seals on my vintage D Engine? The service manual is not really specific. Can this be accomplished with standard tools or will I need to buy specialty tools such as seal remover and installer. Thanks !! |
Follow-Up Postings:
|
| Well you don't seem to be getting much response. I just use a small screw driver to pop the old seals out being very careful to not damage the crankshaft seal area. IF they are stubborn, I drill a small hole in the middle of the metal part, run a small metal screw into it and pull on that. Install using a pc. of plastic pipe or something similar to drive them in place. I have no special tools. Walt Conner |
|
| Thanks Walt. I was hoping to get a response from one of the true LB experts here. I'll give it a shot when I have some time. They are probably due for a replacement since they are still the originals from 1969!!! |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Lawn Mowers Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.