Drive belt Huskee 4600

10 years ago

Just wondering how do you get the drive belt on the last pulley above the transmission for a Huskee 4600 Hydrostatic mower? Not sure the model year.

Sort by:Oldest

Comments (3)

tomplum
10 years ago
I could be of more help w/ the model # from below the seat. In any case, the rear pulley is the 1st or second pulley that gets the belt on most hydros as to clear the fan on installation.
gwhunter
Original Author
10 years ago
Model # 13bs608h131. The issues is the belt has to go on to the second or bottom half of the pulley but I cant get it past the side wall of the frame to get it down.
Related Professionals
Eden Prairie Landscape Architects & Landscape Designers · Kyle Landscape Architects & Landscape Designers · Rancho Palos Verdes Landscape Architects & Landscape Designers · Redondo Beach Landscape Architects & Landscape Designers · Roosevelt Landscape Architects & Landscape Designers · Wareham Landscape Architects & Landscape Designers · Bristol Landscape Contractors · Fort Wayne Landscape Contractors · Hendersonville Landscape Contractors · Norwalk Landscape Contractors · Pacifica Landscape Contractors · Pine Hills Landscape Contractors · Thornton Landscape Contractors · Emeryville Carpenters · Ridgewood Carpenters
tomplum
10 years ago
Your choices on this are to use an impact wrench w/ a couple of extensions and a 15/16" socket to remove the pulley nut so you can move the pulley for clearance. Or loosen/ remove transaxle mounting bolts to lower the transaxle for clearance.