|
| I have a honda mower model HRT216SDA.
I replaced the transmission and clutch arm because the clutch arm was worn as well as the tip that extends up from the transmission where the clutch arm attached. I also installed a new belt. The problems is when I pull the drive control cable the wheels will turn but it has no pulling power. I can see the cable move and when I lift the real wheels off the ground the wheels turn, but as soon as I put the wheels back on the ground the mower will not move. Before reinstalling I checked the gears in the wheels as well as the pinion gears and could see no wear. Any help would appreciated |
Follow-Up Postings:
|
| Are the clutch gears perchance on backwards? If you position the "notch" (one of three) at the top of the gear from a side view, the flat goes to the back. |
|
| I had same problem, new trany in, new cable seem to move about 1/4 of an inch but mower still not have enough force to move on the grass. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Lawn Mowers Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.