Slow snapper quantum xrm
michele3918
10 years ago
More Discussions
Hello everyone,
I have a slow Snapper quantum xrm 6.5 hp, it's frustrating because I can't seem to figure out the cause.
Perhaps some of you can shed some light on the subject and help me figure this out.
I've spent many week ends on this challenging project.
Behavior:
The lawn mower moves too slow even at the highest gear selection. (6 positions)
I use to have to run behind it at that gear selection.
(Yes, I did that on a few occasions)
Basically, it moves as if it was set on the 3nd gear position when it was operating normally.
Troubleshooting steps:
1 Replace driven disc spring-Yes
2 Replace driven disc-Yes
3 Replace all belts-Yes
4 Replace clutch cable upper spring-Yes
Other failed attempts:
I glued some 60 grid sand paper on a stick and ran it on the drive disc with the mower running. I did that to clean the drive disc and to give it some texture for better grip.
I also tried to select a lower gear just to position driven disc on another surface area.
Thats all I can think of right at the moment.
Hope to get some tips soon.
Thanks,
Good week end.
Michele.
robcs
Related Professionals
Maple Valley Landscape Architects & Landscape Designers · New Bedford Landscape Architects & Landscape Designers · Comstock Park Landscape Architects & Landscape Designers · Middle Island Landscape Architects & Landscape Designers · Norton Shores Landscape Architects & Landscape Designers · Tomball Landscape Architects & Landscape Designers · Melrose Park Landscape Contractors · Middletown Landscape Contractors · Oak Harbor Landscape Contractors · Tamarac Landscape Contractors · Vancouver Landscape Contractors · Enterprise Carpenters · Scarsdale Carpenters · Sugar Land Carpenters · Temple Carpenters