|
Sun, Aug 19, 12 at 17:18
| I'd like to inspect the flywheel key on my Toro 20045 with a 6.0 hp engine sometime in the near future. It's got a Briggs 12H800 series engine. I see that the flywheel nut is a 15/16 size. Can I use a regular size 15/16 socket with a short extention to remove the nut or is a deep socket needed for this? Thanks. |
Follow-Up Postings:
|
- Posted by ggoyeneche New Jersey (My Page) on Sun, Aug 19, 12 at 23:32
| It depends how long the shaft stub is on the crankshaft. Usually a deep socket is better. |
|
| I use a standard/ no extension. |
|
| Thanks for the info. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Lawn Mowers Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.