Shop Products
Houzz Logo Print
motorhead1845

craftsman w/ briggs motor will not run

motorhead1845
11 years ago

it ran fine a couple of weeks ago. now it will run only form a few minutes on prime

model number for the engine is 10T802.

anuone have a diagram of the goevrnor spring attachs to the governor?

i cleaned the carb once. plug is good. today plan to clean air filter and gas cap vent.

Comments (2)

  • bill_kapaun
    11 years ago

    Suggest you go to the Briggs website and download the IPL for your engine.
    Replace diaphragm part# 394
    Clean screen Part# 393
    Check ball & inlet Part# 913
    OR buy new carb for about $27

  • rustyj14
    11 years ago

    I'd try the gas cap vent hole first! Little bugs just love to drop an egg in those holes, and seal them up with goo!
    And, if that fails, then go with Bill K's advice. Rustyj.