|
Sun, Jun 6, 10 at 10:25
| My pump quit pumping and I find the split ring on the shaft has come off. There is a flat spot on the shaft and an enlargement in the impeller where it appears some sort of pin should go.
Is this split ring with the projection to stop the impeller from turning on the shaft available from anyone but Sunterra's (I have no idea what the part actually looks like only guessing based on what I see) |
Follow-Up Postings:
|
| Have you contacted Sunterra? They may be able to help. |
|
| They will replace the $100 pump rather than sell or give away the $2 part. Cost analysis at its best. |
|
- Posted by coastal_ponder (My Page) on Tue, Jun 8, 10 at 23:11
| i have had very good service from sunterra. they actually replaced a pressurized filter system sight unseen because what i was shipped didn't have the u/v system i paid for. they told me to keep the non u/v filter. their pump has run 24/7 for almost 3 years now. better run check it........you know what bragging will do. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Ponds & Aquatic Plants Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.