Return to the Ponds & Aquatic Plants Forum | Post a Follow-Up

Thin oil slick on my pond

Posted by Mike56 7a (My Page) on
Sun, Nov 25, 12 at 18:03

This morning I found a thin oil film on my pond. I have a 1 HP Tsurumi submersible pump, about 8 months old that I installed this spring replacing the old one after it quit.

My question is, can something other than the pump be causing the very thin oil film? Decaying leaves, dead frog in the intake or other? The pump is still running and the pond has not iced up at all yet.

Has anyone else seen this condition? Do I need another pump?


Follow-Up Postings:

RE: Thin oil slick on my pond

I noticed this a few days ago on my large mud bottom pond with no pump or any other motor-driven devices in it. I thought it was maybe from run-off from the road that feeds into the creek, which feeds the pond---but there has been a lot more rain in the past with no oil film, so I don't think that's it.

My pond is 110x50' and the oil is over pretty much the whole surface. It is a very light film, though.

RE: Thin oil slick on my pond

Hmmm, That is interesting. Maybe others have seen this and can offer an explanation. We have not had any rain to speak of lately. I am just hoping its not from my pump.

Thanks for your reply spanky
Mike .

RE: Thin oil slick on my pond

I believe that it may be vegation decaying combining with soil elements that produces the oil. I have found this in my small shallow cement mixing trough that I use to grow various water plants in. No fish. I just hose it off until it washes over the sides of the trough as the trough sits on a concrete slab. Once the decay is over the oil will probably disappear with weathering. Have not noticed it in awhile.

RE: Thin oil slick on my pond

I have seen such films in lots of situations where no petroleum oil was present at all. The most interesting and colorful was where something made of iron was involved. As the iron began rusting a film that appeared oily would form on the surface. These films often seem to be a result of oxidation whether the decaying object is organic or non-organic but they can be something else entirely.

Short of having the film tested by a lab, all you can do is flood the pond to get rid of the film and try to locate the source.

Possible sources might be conifers, fertilizers, herbicides, insecticides, oil treatments for trees, rotting wood that has a high pitch content, lots of acorns rotting on the bottom, a dead critter on the bottom, wood preservation treatments and likely a whole slew of other things.

You can check the pump by putting it in a container of warm water and watching to see if the film appears on the surface of the water.

RE: Thin oil slick on my pond

I like terrestrial_man's suggestion that it might be decaying vegetation. We've an old hot tub converted into a outside tank and many mornings when the air temperature is below freezing and the water temperature is near freezing there is foam around floating cattail leaves. Something is happening around vegetation at these temperatures.

RE: Thin oil slick on my pond

Thanks all for the replies. Yesterday I added water to the pond allowing the film to run off through the high level over flow pipe. Today I only saw trace amounts of the film in 2 places arround the edge of the pond where the surface flow is near nonexistant.

I do have 3 long iron stakes to suport a net accross the front of the pond for preditor control and will check the filters out for something dead tomorrow.

At least it does not seem to be from the pump :-)

RE: Thin oil slick on my pond

I have just found an oil slick on my two small ponds (adjacent).

No oil has been near them that I am aware of. However, two possibilities spring to mind:

1. Deposits from smoke of passing farm vehicles (unlikely as these vehicles have been passing forever)

2. A bird has dropped a piece of animal fat in the water (some people do feed that to birds !)

 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!

Return to the Ponds & Aquatic Plants Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.

Learn more about in-text links on this page here