Return to the Tool Shed Forum | Post a Follow-Up

 o
Noma / Murray Snowblower

Posted by HarryP4321 Maine (My Page) on
Fri, Feb 11, 11 at 10:03

I recently acquired a Noma snowblower model 627104X8. This is a 27" cut with a 10hp Tecumseh - vintage 1998. Naturally it did not come with a user's manual nor can I find one on the internet.
I am in the process of refurbing it. I would like to drain and replace the auger gearbox lubricant; however I can not find what type is used on this model. I see references to 00 grease, 80-90 SAE gear lube, synthetic oil and SAE 30. Does anyone know what was used originally. To me, it appears to be SAE 30. I'm leery of using anything other than what it was designed for.
Any help will be appreciated. Particularly the lube type and any specific procedures to use. Also any lead to a user's manual.
Thanx.


Follow-Up Postings:

 o
RE: Noma / Murray Snowblower

I have a smaller Craftsman (8.5 hp/24") made by Noma/Murray from around that year.

The manual is here: http://www.managemylife.com/mmh/lis_pdf/OWNM/L9060302.pdf

You may be able to find an equivalent or similar Craftsman model to the one you have, and use the Craftsman manual.

In the manual for my model, there is a section on Lubrication that says "Hex Shaft and Gears - Hex shaft and gears require no lubrication. All bearings and bushings are lifetime lubricated and require no maintenance."


 o
RE: Noma / Murray Snowblower

Harry , Sae Hypoid 80 Grade Gear Oil will suffice . Dextron Automatic Transmission fluid has also been utilized in Extreme Cold Climate's where -40 -50 F temps are routine .


 o
RE: Noma / Murray Snowblower

where can I get a manul for a nona snowblower model#F245000


 o
RE: Noma / Murray Snowblower

Here is the link to the user manual. Murray didn't even have these any more when I inquired in May 2014. I did send them a copy for future requests.

Here is a link that might be useful: Murray 627104 Snow Thrower


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Tool Shed Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here